A sharp knife is much safer than a blunt one. It cuts cleanly and does not slip, causing few accidents. Yet most people don’t know how to sharpen a knife and keep it sharp. This evening course, run by Bladesmith Karim Haddad, shows you the secrets of getting and maintaining a fine edge. Five different methods will be demonstrated in setting an edge as well as burr removal honing and touching up. Knife care and storage will also be covered to ensure you knife stays sharp. This will be followed with a practical session where you get to sharpen the three knives that you have brought with you.
Cost is $75 for the evening – 7:30pm until 10:00pm.
There is a maximum of only six participants per class.
Location: Tharwa Valley Forge Contact: CIT Solutions 6207 4444
“If your drillings are coming off in any colour byt silver, sharpen the bit” -Les Stanley
Essential Supplies
From our Store
Knifemaking Steel
High carbon steel for bladesmithing. Excellent for forging and heat treating. The steel works well under the hammer and the size is perfect for a range of small to medium blade. This is a simple steel that is oil quenched and shows hamon lines very clearly when heat treated correctly. Perfect for Japanese style blades. You should get between 4 and 6 blades per length. 15N20 is the same as 1075 with an additional 2% nickel. It makes a high contrast pattern when combined with either 1075 or 1055 in Damascus steel.
1055 - 4mm x 25mm x 530mm (annealed) 400g - $10 per length
1075 - 3mm x 25mm x 450mm (spring tempered) 250g - $15 per length
15N20 - 2mm x 25mm x 500mm (annealed) 200g - $15 per length
Postage/freight extra. This is in limited supply so contact us now to order.
